Crankshaft de-balancing machine with good application of micro-lubrication
It is widely used in the construction of the projects e. G. Prospecting, railway, road, port, bridge, water conservancy and hydropower, well, industrial and civil construction, geological exploration, especially used in mining wireline diamond core drilling and inclined hole wireline core drilling, etc.
1.Products Description:
Drilling Rig Tower,Oil Rig Tower,Drilling Tower,Oil Drilling Tower JIANGSU XI TEC ENVIRONMENTAL&DRILLING EQUIPMENT COMPANY CO.LTD , https://www.xitecdrillingwx.com
If the balance bearing bush is lubricated with a small amount of lubrication , this problem can be effectively solved and many benefits will be obtained:
1, using a small amount of lubrication , can reduce the consumption of oil, energy saving and environmental protection;
2. The running cost of the micro-lubrication system is very low. It is powered by compressed air and has low energy consumption.
3, can reduce the use of oil lubrication when the chip stuck between the bearing and the journal caused damage and other issues;
4, can provide a good lubrication to the drill, improve the service life of the drill.
Compared with the traditional lubrication method, the advantages of the trace lubrication can be described as many. In order to ensure a slight amount of lubrication, the following two points require special attention:
1. Dry and stable gas source: The stability of the gas source pressure is an important factor in the normal operation of the micro-lubrication device. The power source of the micro-lubrication device is compressed air, so the stability of the compressed air pressure is very important. The moisture in the compressed air will directly affect the atomization effect and further affect the lubrication effect. Therefore, the stability of the gas source pressure and the drying of the gas source are very important.
2. The design of the oil mist output channel of the balancing machine bush is very critical, and its rationality directly affects the bearing lubrication effect. For the design of the bearing bush, the actual design of the bearing bush does not need to be too large. Generally, the bearing bush can be calculated according to the size of the bearing. Trace lubrication itself has a small diameter at the lubrication terminal. If the passage is too large and the air supply is insufficient, the output of oil mist will be too large, which will affect the operating environment. Therefore, we must fully consider when designing.
The mast (derrick) type is generally classified as A type, K type, tower type and mast type etc.
A type mast, its leg section is rectangular or triangle shape, with better loading capacity and stability,connected with pins between sections, installed at low level and erected or lowered down integrally by drawworks and A-frame.
K type mast, namely front opening mast, its transverse section is a shape truss structure, its both sides are composed of several pieces or segments, its back is rigid frame or pole system of truss, connected with pins or bolts between segments and members, may be installed at low level and erected or lowered down integrally by drawworks or hydraulic cylinder, has the advantages of convenient installation and teardown, excellent rigidity.