Level transmitter maintenance and maintenance
1 Introduction The liquid level transmitter is a commonly used transmitter for domestic liquid level measurement. It has a simple structure and is easy to install. It is very accurate for the liquid level measurement, so it is trusted by many manufacturers. Today, we will talk about the liquid level transmission. Those maintenance methods and maintenance procedures during use. Second, maintenance : 1. Check the two transmitters on the site first to check whether the transmitter's range has a selection or manufacturing error. 2. Verify the zero position of the two transmitters to see if there is a pressure relief problem. (The result is zero normal) 3. Please confirm that the two transmitters in the field must be consistent with the on-site installation method when adjusting. Then, under this precondition, please check the transmitter's capsule for foreign matter or media crystallization, because if there is foreign matter or crystallization, the pressure will change, and the final 4-20 mA output signal will become larger. 4, the above 3 points have been checked, no problem, the result of the final inspection of zui is a small detail, it is not any of the above possible situations, that is, there is a ball valve in the installation part, there is a rubber pad inside, and the result is not taken down. Negative pressure is generated, which affects pressure changes and output. Of course, this kind of detail is impossible to think of. Only one factor can be found and checked. However, if you do not check, check, and separately according to the theory, it is easy to judge the error, resulting in a normal transmitter but to return to the factory for repair, it is a thankless thing. Having rich experience and excellent design team in the Overhead Crane, Gantry, Crane Parts , Open Winch , Electric Chain Hoist and Electric Wire Rope Hoist Crane industry, Eurocrane provides customers with cranes for special applications, for example, nuclear power, paper-making, shipbuilding, metallurgy and foundry, aircraft manufacturing, waste incineration, etc. Other Crane Products,Other Crane Product,Other Engineering Crane Products EUROCRANE GLOBAL , https://www.craneparts.pl
1. When the liquid level transmitter freezes in winter, the transmitter installed outside must take anti-freezing measures to prevent the liquid in the pressure inlet from expanding due to the volume of the ice, leading to damage to the sensor. 2. When wiring, pass the cable through the waterproof connector (accessory) or the winding tube and tighten the sealing nut to prevent rainwater from leaking into the transmitter housing through the cable. 3. When measuring the pressure of the gas, the pressure port should be opened at the top of the process pipe, and the flange level transmitter should also be installed in the upper part of the process pipe to allow the deposited liquid to be quickly injected into the process pipe. 4. When measuring the steam or other high temperature medium of the liquid level transmitter , it is necessary to add a condenser such as a buffer tube (coil tube), and the operating temperature of the transmitter should not exceed the limit. 5. Double flange liquid level transmitter should pay attention to the pressure guiding tube of the sensor to be installed in a place with small temperature fluctuation. 6. When measuring the liquid pressure, the installation position of the flange liquid level transmitter should avoid the impact of liquid (that is, water). Hammer phenomenon), in order to avoid sensor over-voltage damage. 7. When measuring the liquid pressure, the double-flange liquid level transmitter should be opened on the side of the process pipe to avoid sedimentation. 8. Prevent the flange liquid transmitter from coming into contact with corrosive or overheated media, and prevent the dross from depositing in the conduit;
Third, the fault problem steps are as follows: (sorting in no particular order)
Eurocrane relies on its strong manufacturing processes and production equipment to provide customers with special cranes which, safer and more reliable, have reasonable structural design and more security options ensuring the safety and life, meeting customers` different needs under various operating conditions.